Feeds:
Posts
Comments

Posts Tagged ‘build your own’

Following on from Part 3, our motor controller has been successfully built and tested, now it’s time to release the parts used, where to place them, etc so you can build your own. I’ve actually taken consideration to what I said in Part 3 and have re-designed the Motor Controller to have the components and lines to be spaced out a bit more however I’ve changed the lines back to 0.254mm wide. You have the option of both v1.0 or v1.1 boards, I recommend v1.1 even though it is a little bigger.

(more…)

Read Full Post »